Need pics for holley HiRam setup ( Fbody)
Thread Starter
TECH Fanatic
iTrader: (3)
Joined: Mar 2007
Posts: 1,591
Likes: 0
From: Middle east , Kuwait
Need pics for holley HiRam setup ( Fbody) Hi , I gonna install the hiram intake forward throttle for my 2001 Trans Am , I have TSP 100MAF and 102mm throttle .
I need pics for how the setup installed , Because I don't know the sizes for the hoses and how the air filter installed .
Here's pics for the intake
http://alzilzilracing.com/media/holl...am-intake-ls7/
Thanks !
I need pics for how the setup installed , Because I don't know the sizes for the hoses and how the air filter installed .
Here's pics for the intake
http://alzilzilracing.com/media/holl...am-intake-ls7/
Thanks !
Nope. The hi-ram is too tall, and that's the shorter of the three we tested (ls7). You could also weld/box the back part of the hi-ram top for clearance and probably make it fit, but it certainly won't out of the box
Thread Starter
TECH Fanatic
iTrader: (3)
Joined: Mar 2007
Posts: 1,591
Likes: 0
From: Middle east , Kuwait
THX guys , Well for the air filter and Maf ,,, I would to see pics how those setup installed ?
I already cut the cowl and gonna cut the glass , If Hood also hitting ill cut , The hood is 4inch raised
I already cut the cowl and gonna cut the glass , If Hood also hitting ill cut , The hood is 4inch raised
Many people have run the rectangle port holleys without cutting glass. Its close, solid motor mounts are a must but its doable. We just installed one on a buddies 02 SS. The cathedral version is almost an inch taller and requires the glass to be cut for sure. Look around there are plenty of pics of the ls3/ls7 version installed in fbodies.
