LS7 rings
Thread Starter
TECH Fanatic
iTrader: (3)
Joined: Mar 2007
Posts: 1,591
Likes: 0
From: Middle east , Kuwait
LS7 rings I have LS7 engine , i'll rebuild it because it has bad rings and smoking , wich ring should i go with ?
- 4.125 Bore, 1.5 - 1.5 - 3.0 mm
or
- 4.130" + .005" 1.5/1.5/3.0
?
- 4.125 Bore, 1.5 - 1.5 - 3.0 mm
or
- 4.130" + .005" 1.5/1.5/3.0
?
LS7 sleeves aren't thin. Bored them +.030 for N/A to patch up a block.
One issue have with them, 90% of pistons for them are 4.125", the block itself is 4.126", once you go to hone the block its only going to get bigger. I'd like if the piston companies would make pistons 4.127" or 4.130" more so then 4.125".
If you're reusing the stock pistons, i'd go with 4.125 +5.
One issue have with them, 90% of pistons for them are 4.125", the block itself is 4.126", once you go to hone the block its only going to get bigger. I'd like if the piston companies would make pistons 4.127" or 4.130" more so then 4.125".
If you're reusing the stock pistons, i'd go with 4.125 +5.
