Long block idea.(scratch that) built motor idea
Long block idea.(scratch that) built motor idea still trying to figure out my plan for my master powerplant. Im almost finished installing my 9inch fab rear with all the goodies and figured its a good time to start getting a parts list together for my cold weather project. I want a good street/strip motor with 427CI. Im thinking a Sleeved ls2 block with a 4.125 bore. I am thinking of using a decent callies 4in stroker kit with forged pistons to run 11.5.1 with p/p L92 heads.
I am trying to figure out which cam to go with. I might buy two and try them both out. Im looking for max power with maximum streetability. It needs to run on pump gas.
I am planning on running at least a 90mm intake and throttlebody.
just looking for advice on fuel delivery, with pump and injector sizes and a good cam/valvetrain idea. I dont want to go over 6k-6800 rpms.
Im looking for 580-600whp through a t-56 and a 9" with 3.89 gears. vroom vroom.
Thanks for any advice. Ill pay the community back with a nice video when the bird is all buttoned up this spring.
I am trying to figure out which cam to go with. I might buy two and try them both out. Im looking for max power with maximum streetability. It needs to run on pump gas.
I am planning on running at least a 90mm intake and throttlebody.
just looking for advice on fuel delivery, with pump and injector sizes and a good cam/valvetrain idea. I dont want to go over 6k-6800 rpms.
Im looking for 580-600whp through a t-56 and a 9" with 3.89 gears. vroom vroom.
Thanks for any advice. Ill pay the community back with a nice video when the bird is all buttoned up this spring.
Last edited by 3500lt; Dec 6, 2010 at 02:36 PM.
