Very small ding in cylinder wall - Insignificant or a potential issue?
#1
Very small ding in cylinder wall - Insignificant or a potential issue?
Was putting heads back on my new build and noticed this very small nick/ding in the cylinder wall. Cannot feel it with the pad of your finder, can BARELY feel something going sideways, but not up and down with your nail, and it's extremely slight if at all.
It's not much bigger than a pinhead and maybe .001-.002 if I had to guess on depth. You can feel it with a dental pick type tool, but that's about it.
Is this insignificant or a potential issue?
Thanks
It's not much bigger than a pinhead and maybe .001-.002 if I had to guess on depth. You can feel it with a dental pick type tool, but that's about it.
Is this insignificant or a potential issue?
Thanks
Last edited by 98RedBird; 03-24-2019 at 03:37 PM.