Pushrod length sanity check
Pushrod length sanity check Specs:
2005 5.3 LH6 Block
799 heads milled .010"
Summit Racing Stage 3 LS Cam (231/242 113+3, .600/.600 Lift)
Fel-Pro 26191PT .048 Head Gasket
Summit Racing SUM-HT214 lifters
Tool:
COMP Cams Pushrod Length Checker 7702-1
Method:
EOIC (exhaust open, intake close)
Results:
Zero lash at ~9.75 to 9.875 turns from closed
Maths:
((9.8 turns x 0.050" per turn) + 6.800" closed length) + .080 preload = 7.37 length pushrods
Guess I should just go with some 7.375 length pushrods?
2005 5.3 LH6 Block
799 heads milled .010"
Summit Racing Stage 3 LS Cam (231/242 113+3, .600/.600 Lift)
Fel-Pro 26191PT .048 Head Gasket
Summit Racing SUM-HT214 lifters
Tool:
COMP Cams Pushrod Length Checker 7702-1
Method:
EOIC (exhaust open, intake close)
Results:
Zero lash at ~9.75 to 9.875 turns from closed
Maths:
((9.8 turns x 0.050" per turn) + 6.800" closed length) + .080 preload = 7.37 length pushrods
Guess I should just go with some 7.375 length pushrods?
I just noticed your cam specs, I'm just finishing up my build LS2 Trick flow 'fast as cast' 220's only I went with the Comp cams 231/239 .617 .624 113+4 109 ICL I assume your going to have it tuned? let me know what it pulls. I'll do the same. maybe later this week.
