LS2 can sensor hitting cloyes double roller.
LS2 cam sensor hitting cloyes double roller. It hits the actual cam sprocket. Is there different sensors with different depths or can you shim them out some. What kinda distance is the sensor looking for to get a accurate reading? Thanks.
Last edited by John02SS; Mar 18, 2008 at 09:16 AM.
FormerVendor
Joined: Jan 2002
Posts: 173
Likes: 0
From: Mpls., MN
Get out the grinder..... I used one on a super stock motor and the only way it will clear is with liberal grinding on the sensor and parts of the cover. In all honesty though, unless you are using springs like we used in said S/S motor (300 lbs + seat pressure - 800 lbs open), I wouldn't waste the time and money on a double roller. We had many road race and stock elim. motors turning over 7500 on a single roller chain without any problems whatsoever.
Brian
HiTech Motorsport
Brian
HiTech Motorsport
I had to grind the sensor for it to go. Seems to be fine, but had to make a mess of a perfectly good sensor! 
I already have the cam in, degreed, and all the valves set or I'd throw the single on. Grinding the sensor was the better alternative!
Mike, What did yall do on the one you used? Yall used one on the vette didn't ya?
I already have the cam in, degreed, and all the valves set or I'd throw the single on. Grinding the sensor was the better alternative! Mike, What did yall do on the one you used? Yall used one on the vette didn't ya?
TECH Resident
Joined: Aug 2004
Posts: 875
Likes: 2
From: Portland Oregon
I wouldn't waste the time and money on a double roller. We had many road race and stock elim. motors turning over 7500 on a single roller chain without any problems whatsoever.
