What are you going to do about the 2 additional studs per cylinder?

 

I called arp and ordered 16 of the smaller studs in the ls2 kit. there 8mm x 1.25.

 

So whats the Price on these heads compared to ETP's??
Is the Spring seat thick enough for a Solid Roller setup??
Rockers been checked for clearence... ie what Jesel Rockers work with it??

Kyle

 

I was quoted about $2500 setup for hyd roller...

 

The spring seat is plenty thick with either a 1.550" or 1.625" spring. We have done a number of these with the mechanical roller setup and have not had any problems. We open the pushrod hole up to work with the Jesel Mohawks and a 3/8" pushrod. We also use a Ferrea valve with 5/16" stems to get a 2.00" installed height. The comp cams and t-d rockers work too. Basically any rocker arm designed to fit standard 15 degree LS-1 heads will fit these fine. Our standard Mech roller setup is $2850.00 and with the 6 bolt is $3050.00

 

Thanks for the info Brian and Mike...... I can see deleted posts

Kyle

 

We can't...

 

Those should work great. Good luck, look foward to the results.

 

i love my TEA 245 trick flows!!!!
' ps, they are set up for solid roller and seem to be doing just fine

good luck man, cant wait to see what she runs

 

How do these heads flow?