Leaking Oil

Reply Subscribe

Thread Tools

Search this Thread

Sep 15, 2018 | 06:34 PM

JScurlock

Thread Starter

Registered User

Joined: Sep 2018

Posts: 1

Likes: 0

Leaking Oil

Just installed a new 418 short block from Texas Speed on Labor Day. On first start up once engine was warm it starting leaking oil between the back of the motor and bell housing. So last weekend I removed the transmission and install new seals and gaskets for the 2nd time again same problem. So this weekend I replaced them again and guess what same problem. So frustrating!! I have been using the ultra black RTV I am out of options other then taking it to a shop. Any advice would be much appreciated. This is on a 2010 camaro. Thanks

Sep 15, 2018 | 07:50 PM

G Atsma

TECH Senior Member

Joined: Jun 2016

Posts: 22,301

Likes: 3,625

From: Central Cal.

Why is this in Gen V??
Are you making sure the oil pan, rear cover and block are flush with a straightedge?

Sep 15, 2018 | 09:47 PM

Che70velle

ModSquad

iTrader: (6)

Joined: Jan 2012

Posts: 7,866

Likes: 5,225

From: Dawsonville Ga.

How are you venting the engine up top?
As G pointed out, you should have posted in gen4 section. You’ll get more response there also.

Sep 19, 2018 | 05:24 PM

00pooterSS

TECH Veteran

iTrader: (40)

Joined: Mar 2008

Posts: 4,920

Likes: 531

From: Dallas

Have you tried another oil pan gasket yet? I've seen a couple of oil pan gaskets do that and one time I did a rear main and when I slid the rear main plate on it pushed the rubber off of the oil pan gasket and leaked bad.

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last