Advice please
Thread Starter
Registered User
Joined: Apr 2013
Posts: 0
Likes: 0
Advice please hey all, well Last summer I purchased a 95 camaro, unfortunatly it is a v6. I decided that I was ready for a v8, so yesterday I got a semi complete lt1, I plans on doing a complete rebuild of the engine.
This is my first build so any advise would be greatly apreciated, thank you.
I will post pictures tomorrow of the disassemble.
This is my first build so any advise would be greatly apreciated, thank you.
I will post pictures tomorrow of the disassemble.
Thread Starter
Registered User
Joined: Apr 2013
Posts: 0
Likes: 0
Ya, ive been checkina them out I think the le 1 setup would be sufficient for the power imma lookin for, but then again for a couple more hunded could do up to 400 hp, im deff leaning torward doin all forged bottom end to start, taking it to machine shop this week, my nexy questions is stock bore, or go .0300 over and go for 383...
My plans is 350 to 400 hp at wheel, im not sure on the budget as ill be buying the parts slowly over next few months. Do I really need forged internals for 400 hp, or could I get away with some cast parts?
Prolly just keep it n/a for this project, thank you.
My plans is 350 to 400 hp at wheel, im not sure on the budget as ill be buying the parts slowly over next few months. Do I really need forged internals for 400 hp, or could I get away with some cast parts?
Prolly just keep it n/a for this project, thank you.
