New to the forum
Thread Starter
Teching In
Joined: Oct 2021
Posts: 0
Likes: 0
New to the forum Hey LS1Tech
New guy here, used this forum quite a bit during for my build, not sure why I didn't sign up earlier...
I've got an '86 Chevy G20 van that I'm installing an lq4 into on a budget(kinda). So far I've done:
AFR enforcer heads
elgin 1840p cam
btr push rods
ls7 lifters
summit forged flat tops w/ 2cc reliefs
new rings
melling oil pump
psi harness
Block honed and cleaned up
New cam bearings
bottom end balanced.
dirty dingo mounts
I'm bolting this up to a refreshed 4l80e w/ trans go hd2 kit.
Hopefully this gets my van moving a little better than the 400ci smogger and th350 thats in there now. Getting ready to test fire before I pluck the old running gear out and drop this in.
New guy here, used this forum quite a bit during for my build, not sure why I didn't sign up earlier...
I've got an '86 Chevy G20 van that I'm installing an lq4 into on a budget(kinda). So far I've done:
AFR enforcer heads
elgin 1840p cam
btr push rods
ls7 lifters
summit forged flat tops w/ 2cc reliefs
new rings
melling oil pump
psi harness
Block honed and cleaned up
New cam bearings
bottom end balanced.
dirty dingo mounts
I'm bolting this up to a refreshed 4l80e w/ trans go hd2 kit.
Hopefully this gets my van moving a little better than the 400ci smogger and th350 thats in there now. Getting ready to test fire before I pluck the old running gear out and drop this in.
