Hey whats up everyone, Names Joe and Sometimes i come on this forum when searching for some troubleshooting on my build, currently doing a full restoration, Frame off of 1962 Chevy Impala Convertible SS - LS1 swap

car is about 90% done - finishing up the little things on the motor, like hard lines for steering and brakes - Radiator lines etc - Exhaust shop, Top and interior and then iron out the kinks - so close but so far sheesh lol always 3steps forward and 2 steps back with these builds

I am currently stumped on making my throttle cable i purchased from Lokar work with my stock pedal assembly - could be simple but personally i'm stuck

I purchased the bracket that mounts the cable to the manifold, that's straight forward. trimming the cable is straight forward as well - but making it work with the bracket (pedal linkage) near the firewall is the part i dont understand

anyways some insight would be appreciated

Accufab Throttle body, bracket i purchased mounts to manifold for the front part of the throttle cable and then line goes back to the pedal assembly bracket by firewall - stumped on that last part