Outer Diameter or our MAF's
Thread Starter
12 Second Club
iTrader: (11)
Joined: Feb 2009
Posts: 570
Likes: 0
From: Plainfield, IN
Outer Diameter or our MAF's let me know if you could....OUTER DIAMETER...somebody go measure LMAO..seriously..im at work lol I just need to know...and the OD of the intake too if someone could...
LS1Tech Sponsor
Joined: Dec 2005
Posts: 2,932
Likes: 12
From: CT
I know on my Monte SS, when I replaced the stock accordion intake hose with a silicone hose, it was a 3.25" I.D. hose that was needed to go over the MAF end and throttle body... so, the OUTER diameter of the MAF and throttle body should be 3.25"...
hope that helps...
hope that helps...
__________________
06MonteSS / DiabLew Tune
2014 Camaro 2SS/RS - LS3, 6-speed manual, short-throw performance shifter, NPP dual-mode performance exhaust, 1LE front splitter, ZL1 rockers, Z28 Rear Spoiler, all paint-matched Red Rock Metallic, BMR strut tower brace, Cold Air Inductions cold air intake, Apex Motorsports, Inc. catch-can, Custom DiabLew Tune
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com
06MonteSS / DiabLew Tune
2014 Camaro 2SS/RS - LS3, 6-speed manual, short-throw performance shifter, NPP dual-mode performance exhaust, 1LE front splitter, ZL1 rockers, Z28 Rear Spoiler, all paint-matched Red Rock Metallic, BMR strut tower brace, Cold Air Inductions cold air intake, Apex Motorsports, Inc. catch-can, Custom DiabLew Tune
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com
Thread Starter
12 Second Club
iTrader: (11)
Joined: Feb 2009
Posts: 570
Likes: 0
From: Plainfield, IN
yeah, this helps out a bunch guys...THANK YOU...trying to figure out what MAF im going to run for this turbo...lol..got the IC and pipe up and ran, but now its a reducer and coupler game for the MAF...im going the LS7 MAF route i think...so that means im going to have to come off the intake at 3.25" up to a 4.00" over the LS7 MAF and then from the LS7 MAF 4.00" down to 2.5"....i dont like that idea...i think i need to step down in pipe to...not just purely reducers LOL
