What i did today
Thread Starter
TECH Resident
iTrader: (1)
Joined: May 2008
Posts: 800
Likes: 1
From: Minnetonka,MN or Fargo
What i did today im going to revisit my intake setup for when i put on the ported mani and tb spacer ill have a whole new system i decided i would do it in cad the maf is all approx dimentions except the o.d. not perfect by any means but not bad for an afternoon
Thread Starter
TECH Resident
iTrader: (1)
Joined: May 2008
Posts: 800
Likes: 1
From: Minnetonka,MN or Fargo
overall i prefer hand drawing because im not limited by anything and it has a spicific aestetic to it.... all nice omputer renderings will look very similar... but
autocad im good with just plans and 2d stuff
autodesk inventor is what i did this in
3ds max is what i usually use to render place material maps and do animations
autodesk revit is what i need to learn next since its an industry standard in architecture i have a basic understanding but it is too limiting
in high scool i used a program called chief architect which i was decent in too
and of coarse as a suppliment photoshop and indesign are a must
old autodesk inventor stuff...
Autocad then photoshop
chief...
3ds max
Combo
autocad im good with just plans and 2d stuff
autodesk inventor is what i did this in
3ds max is what i usually use to render place material maps and do animations
autodesk revit is what i need to learn next since its an industry standard in architecture i have a basic understanding but it is too limiting
in high scool i used a program called chief architect which i was decent in too
and of coarse as a suppliment photoshop and indesign are a must
old autodesk inventor stuff...
Autocad then photoshop
chief...
3ds max
Combo
