Headers installed and new exhaust pics
05-05-2011, 06:33 PM
#22
12 Second Club
Thread Starter
iTrader: (14)
Join Date: Jun 2007
Location: Renton, WA
Posts: 2,563
Likes: 0
Received 0 Likes
on
0 Posts
Well I took the car back into Stans headers to have them install the cutout, but I changed my mind and had them run
3" pipe up to the split. My phone was dead at the time, so I had to snap some pics with the car on the ground.
In a nut shell; I am now 3" up to the rear Magnaflow dual exhaust split and 2.5" from the split out. All piping is mandrel bent.
3" pipe up to the split. My phone was dead at the time, so I had to snap some pics with the car on the ground.
In a nut shell; I am now 3" up to the rear Magnaflow dual exhaust split and 2.5" from the split out. All piping is mandrel bent.
Last edited by DavidGXP; 05-05-2011 at 06:40 PM.
06-01-2011, 12:21 PM
#32
Staging Lane
iTrader: (1)
Join Date: May 2011
Location: Milwaukee,WI
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Thanks! Is it just a 3" universal Hi flow magnaflow cat? Does the flex pipe come with the headers? I plan on running this into my stock rear mufflers and currently have a cutouts on the back curve before the mufflers.
06-01-2011, 12:43 PM
#33
12 Second Club
Thread Starter
iTrader: (14)
Join Date: Jun 2007
Location: Renton, WA
Posts: 2,563
Likes: 0
Received 0 Likes
on
0 Posts
It's a universal cat and the flex coupler was seperate. I can dig up some part numbers for later. I have an extra 3" coupler if your interested.
06-01-2011, 01:51 PM
#34
Staging Lane
iTrader: (1)
Join Date: May 2011
Location: Milwaukee,WI
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Sure that would be great if you could get the part numbers. I will be having a exhaust shop weld it all up with a resonator delete. That is once I get and install the DT headers.
06-01-2011, 03:15 PM
#35
12 Second Club
Thread Starter
iTrader: (14)
Join Date: Jun 2007
Location: Renton, WA
Posts: 2,563
Likes: 0
Received 0 Likes
on
0 Posts
