Cut out Placement.
Thread Starter
Launching!
Joined: Mar 2008
Posts: 254
Likes: 0
From: Parts Unknown
Cut out Placement. For any anyone out there who has Electric Cut outs I was wondering where did you place them on your exhaust. Also I have a Magnaflow Stainless cat-back system and was worried about the installation as I know a lot if shops don't weld Stainless steel.
I have mine placed in the very first picture you see in this post:
https://ls1tech.com/forums/ls4-perfo...ut-cutout.html
I have a few scars on the bottom of the cutout from going over speed bumps too fast and bumpy roads. It fits good. It also should not matter for a shop to weld on stainless. Make sure you get the 3 inch cutout if you do have the magnaflow cat back instead of the stock 2.5 inch
https://ls1tech.com/forums/ls4-perfo...ut-cutout.html
I have a few scars on the bottom of the cutout from going over speed bumps too fast and bumpy roads. It fits good. It also should not matter for a shop to weld on stainless. Make sure you get the 3 inch cutout if you do have the magnaflow cat back instead of the stock 2.5 inch
