Is header installation possible???
Thread Starter
Staging Lane
Joined: Dec 2006
Posts: 96
Likes: 0
From: New York
Is header installation possible??? ok now the big question ,......Is it possible to get headers on a front wheel drive?????
Yes I know the front is a piece of cake and so is the cross pipe BUT!!!!! What about the back?????????????? I cant even see Nothin'.......... Not from the top side........... Not from the bottom side.........Any thoughts?
Yes I know the front is a piece of cake and so is the cross pipe BUT!!!!! What about the back?????????????? I cant even see Nothin'.......... Not from the top side........... Not from the bottom side.........Any thoughts?
we've been doing it on the fwd 6 cylinder wbody cars for years now. My headers on my 97 gtp have 1 and 3/4" primaries and 3 inch crossover and outlets. the ls4 is quite a bit tigher though but i'm sure they are already in the works.
TECH Apprentice
Joined: Feb 2006
Posts: 359
Likes: 0
From: Ohio
Not only should SOMEBODY be able to make headers, but These cars should be able to have a true dual exhasut. If the pipe going over the trans was set a bit more to the driver side and the rear manifold (or ideally header) outlet was moveD a little to the pass side there would be enough room for a true dual set up.
Well I heard somewhere that Edlebrock was designing some and they put a price out tha t was well over $1500 for a set ($2000 range, but don't quote me). True duals would be sick, but that would make the primaries a TIGHT fit.
