TA Hatch installation?
Thread Starter
TECH Resident
Joined: Oct 2008
Posts: 966
Likes: 0
From: Redondo Beach, CA
TA Hatch installation? (Reposting here because the Firebird thread has no traffic at all 
)
Hey guys, i'm replacing my 93 formula hatch with a TA hatch.
From my understanding, i can see that there are four bolts holding the hatch up, as well as the wire harness and the shocks.
I figured out how to remove the shocks, but how do you remove the harness and the bolts? What is the correct procedure?
Thanks!
)Hey guys, i'm replacing my 93 formula hatch with a TA hatch.
From my understanding, i can see that there are four bolts holding the hatch up, as well as the wire harness and the shocks.
I figured out how to remove the shocks, but how do you remove the harness and the bolts? What is the correct procedure?
Thanks!
Thread Starter
TECH Resident
Joined: Oct 2008
Posts: 966
Likes: 0
From: Redondo Beach, CA
You have to take off the A pillar plastic trim panels, the kick panels that run beside the seats, and the sail panels on either side of the rear seats. It sounds like a lot of work but once you know how to do it you can get it all out in like 10-15 min.
Thread Starter
TECH Resident
Joined: Oct 2008
Posts: 966
Likes: 0
From: Redondo Beach, CA
Does anyone have a DIY on how to do this?
