so i just finished my single plane install today.. it is a stock bottom end,cc503,P&P heads 270/210cfm,crane10308-1 springs,1.6 pro mags,42lb injectors,90mm fast tb,a-1000 fp reg.,lt4km,85mm slp maf,ram air,single plane intake w/custom sheetmetal elbow.. the car made 360rwhp & 402rwtq untuned limited at only 5100rpm before going lean..so there was more left in it for sure.. but i have not had a chance to fully tune it yet..i just put the 42lb injectors in the tune so it would run okay.. but i did drive it up the road and i can tell you it has absolutely no torque..lol witch is obviosly cause of being untuned but.. i will be dyno tuning it this week so it will be interesting to see the difference.. any thoughts on what it will make? and does anybody have any experiece tuning the single planes on here? what are the main areas to consentrate on?

 

post some pics sounds nice

 

What intake did you go with?

 

 

ill try and get some pics up tonight..lol