Hmm i think i have a problem.
#1
Staging Lane
Thread Starter
Join Date: Nov 2008
Location: Fresno ca
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Hmm i think i have a problem.
Short story. I had just bought some new tires for the t/a i was on my way into town. I notice the engine cut out for a brief second. then its fine. then it does it again. I think im doing a corner in 6th the gears to low. i change up does the same thing IT throws a code. I stop by my work to have it scanned. IT threw a MAF code. It would only seem to cut out as the CE light would turn on and off. I put on some MAF cleaner and took it around the block. Could it be something that simple?
#3
mine is doing something similer, but mine only dose it on the top end and only on a high load. its not hitting the revlimiter and i do have have 1.6 rockers and full bolt ons with no cats. is it possible that i need to go to a 28lber ls1 injecter? and it also is giving me that maf code.
Last edited by lt1blackbird; 01-11-2009 at 07:56 PM. Reason: left something out
#4
TECH Senior Member
iTrader: (36)
mine is doing something similer, but mine only dose it on the top end and only on a high load. its not hitting the revlimiter and i do have have 1.6 rockers and full bolt ons with no cats. is it possible that i need to go to a 28lber ls1 injecter? and it also is giving me that maf code.
#5
Staging Lane
Thread Starter
Join Date: Nov 2008
Location: Fresno ca
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
i cant recall the detail but it was code "48" for obd1. Im going to change the plug wires i did find two bad ones. So those are next on the list reguradless.