LS1TECH - Camaro and Firebird Forum Discussion
SBC-BBC-LT1-LT4 PERFORMANCE
LT1-LT4 Modifications
LS1 Lid conversion questions

LT1-LT4 Modifications 1993-97 Gen II Small Block V8

LS1 Lid conversion questions

Reply Subscribe

Search this Thread

Old

Jan 22, 2009 | 06:15 PM

#1

Thread Starter

TECH Fanatic

iTrader: (12)

Joined: Aug 2007

Posts: 1,818

Likes: 1

From: Cornfields near Pontiac, IL

Default

LS1 Lid conversion questions

Gathering parts for the swap.

I have the slp lid and k&n filter, i just need the base, but where do i find a coupler for that goes between the throttle body and the MAF? The TB is an oval outlet and the MAF is round.

I plan on getting a 4 inch cowl hood for the camaro, will the ls1 lid and base fit under there without any cutting?

Old

Jan 22, 2009 | 06:22 PM

#2

On The Tree

iTrader: (2)

Joined: May 2006

Posts: 131

Likes: 0

Default

I have a ram air hood on my trans am and it clears just fine.
For the lid to maf I used a hump hose. I beleive 3.5 inch.

Old

Jan 22, 2009 | 06:24 PM

#3

On The Tree

iTrader: (2)

Joined: May 2006

Posts: 131

Likes: 0

Default

For the throttle body I'm pretty sure it is a 4 inch silicone. Can't remember.

Old

Jan 22, 2009 | 06:26 PM

#4

Thread Starter

TECH Fanatic

iTrader: (12)

Joined: Aug 2007

Posts: 1,818

Likes: 1

From: Cornfields near Pontiac, IL

Default

where did u buy it? hardware store or online?

Old

Jan 22, 2009 | 06:38 PM

#5

On The Tree

iTrader: (2)

Joined: May 2006

Posts: 131

Likes: 0

Default

Silicone hump hose I got off ebay. The straight piece I used from my slp cold air that I had before putting this on.

Reply Subscribe

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 05:12 AM.