Super budget nitrous build?
TECH Senior Member
iTrader: (3)
Joined: Oct 2006
Posts: 7,564
Likes: 4
From: Decatur, TN (N-W of Athens)
Thread Starter
TECH Fanatic
iTrader: (5)
Joined: Aug 2007
Posts: 1,053
Likes: 1
From: colorado springs Elevation: 6035 ft
Check the SIG. Got plugs, got, timing control, got fuel pump, got injectors. Im about to make my own hotwire kit this weekend. Will stock lt1 heads flow a 200 shot?
I'll take your word on it then. Just throwing out what the guys that sell the stuff said and from some of those who have ran it..
Last edited by Elliott's94Z; Feb 27, 2009 at 01:44 AM.
TECH Senior Member
iTrader: (3)
Joined: Oct 2006
Posts: 7,564
Likes: 4
From: Decatur, TN (N-W of Athens)
And Pyro, I notice you have all the necessary gear, it was just more of an off-topic but on-subject bit
I'm thinking that the heads probably could do a 200, but you'd gain much more out of it (see: worth your while) if they had some work done to them. That's just me though, if I were going to put a 200 on it, and the motor was already out. As you're going to want to put new head gaskets on it anyways. I'd suggest studs too!
I run 150. But I also have colder plugs, and my mallory box is pulling 6 degrees of timing on the jug. My only problem is the stock pump doesn't have enough ***** to feed the cam and the spray. Otherwise no problems yet. I would recommend a wide-band if you are going to spray that much, but thats me.
D
D
