Finally got my exhaust on!

Reply Subscribe

Thread Tools

Search this Thread

May 11, 2009 | 12:58 AM

#21

Bowtie Boy

TECH Resident

Joined: Dec 2005

Posts: 856

Likes: 0

From: In a house

Quote:

Originally Posted by Bad_tx_Z28

well i went for a drive today, and i had a little malfunction. My exhaust hanger broke. But its okay. Im gonna take it to my buddies shop in the morning and have hime re-weld it on. But other than that i felt a good SOTP increase. So all in all im pretty sattisfied.

So you didnt notice any low end power loss? Heard some people say open headers or using cutouts they notice low end torque loss. Although your setup is a couple steps away from a cutout. Im curious.

May 11, 2009 | 01:09 AM

#22

R.E.double.D.

On The Tree

Joined: May 2009

Posts: 192

Likes: 0

From: ARLINGTON TEXAS

Quote:

Originally Posted by bowtie boy

so you didnt notice any low end power loss? Heard some people say open headers or using cutouts they notice low end torque loss. Although your setup is a couple steps away from a cutout. Im curious.

you dont always see a power loss with a cut out

May 11, 2009 | 09:30 AM

#23

Bad_tx_Z28

Thread Starter

TECH Resident

iTrader: (3)

Joined: Sep 2007

Posts: 829

Likes: 1

From: St Petersburg Florida

Quote:

Originally Posted by porksoda

How far out did you run it? Is it dumped right before or after the rear? I wanna do something like this but for sure out the back. I can barely deal with the drone of my cutout when it is open.

i dumped it right at the rear end. There isnt too much drone, it doesnt bother me too bad.

May 11, 2009 | 10:45 AM

#24

Andys94Z

On The Tree

iTrader: (2)

Joined: Mar 2008

Posts: 109

Likes: 0

From: Oak Brook, Il

Berger Panel FTW!!!!!

sounds good! i am about to put basically the exact same setup on my 95, thats a flowmaster single chamber? any chance you could get another clip up for me? what were the RPM's you revved to in that video?