Six Speed Guys! What T/A
Thread Starter
Teching In
Joined: Mar 2009
Posts: 14
Likes: 0
Six Speed Guys! What T/A What is a good torque arm to run. I have the BMR trans mount now but it is going in the trash. I was look for the T/A that mount on the cross member. I have been looking at the Burkhart severe duty, it looks just like the madman one but around $300 ceaper. What will be the best one to get?
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
+1 for the umi full length adj. then new design is great i beat the crap out of it with my m6 and it holds up great. The relocation kit is for sure something to look into to help take the stress off the tailshaft
Ah. I'm still on the Y, although my DSL does touch the Y, but it's so tight there isn't any rattle. I do feel the 9" tons more now over 65mph, since all that is now forced right to the floorboard basically.
I do realize that I'm a LS1 also, but most of this Chassis/suspension stuff carries over.
I do realize that I'm a LS1 also, but most of this Chassis/suspension stuff carries over.
I have the tunnel mount UMI, have barely enough clearance for my 3" y-pipe into 4" single. Only one run on my car so far, so haven't really gotten into tuning the rear suspension much.
Joined: May 2002
Posts: 3,299
Likes: 2
From: windsor, ont. canada - Home of the fastest LT1 6spd.
looking at the cross brace mount is pretty week! just my .02 i have run the bmr x treme duty for 8 years now! 1.27 60' .
the madman piece looks reallyy nice too, and everyone know's his stuff works well!
so you have options.
the madman piece looks reallyy nice too, and everyone know's his stuff works well!
so you have options.
Thread Starter
Teching In
Joined: Mar 2009
Posts: 14
Likes: 0
The T/A that I have is the fully adjustable one but I think that it is time for and up grade. All the rest of my suspension is UMI so i might just go with there T/A. Thanks for the input guys!
Last edited by meaty97z; Jan 28, 2010 at 07:39 AM.
What is a good torque arm to run. I have the BMR trans mount now but it is going in the trash. I was look for the T/A that mount on the cross member. I have been looking at the Burkhart severe duty, it looks just like the madman one but around $300 ceaper. What will be the best one to get?
MADMAN is a chassis fabricator he did a ton of true R&D on his suspension fabrication. VERY KNOWLEDGABLE