Any IDEAS???

Reply Subscribe

Thread Tools

Search this Thread

Apr 1, 2010 | 10:46 PM

my1994z28

Thread Starter

On The Tree

iTrader: (3)

Joined: Jul 2009

Posts: 126

Likes: 0

From: michigan

Any IDEAS???

Just wondering what hp #s and times i might get with my new lt1heads,cam,and edelbrock intake?motor is .020 over,heads are cnc ported with 2.00 1.56 valves and flowed 270.3 intake and 198.4 exhaust,@.600 lift,cam is a comp custom grind,.576 intake and .576 exhaust with a 1.6 rocker,edelbrock air gap intake fully ported,58mm tb,pace setter lts,egr delete,air delete,under drive pulleys,3.73 gears,t56 trans,msd ignition,spec 3 clutch,tb by pass,k&n cai,flowmaster cat back,I plan on shifting @6500 or6800rpms,I also have arp studs holding the mains,and arp rod bolts with scat rods.also have adjustable torque arm and panard bar.

Last edited by my1994z28; Apr 1, 2010 at 11:20 PM.