Where to cut it out?
Where to cut it out? I should be getting my cut out put in pretty soon and I'm curious where people have had luck putting it? I'm thinking maybe a little further back from there the cat used to be on the y-pipe? Would this be too close to the headers and give me issues with the backpressure? I dont want to bend a valve or screw something up with this thing.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Who needs a write up? lol Just do it. Run a power wire and a ground wire to the switch. Put the plate on the pipe, and run the wire from the electric motor to wherever the switch is at.
Me too, but it really doesn't take that much. find a spot in the fuse panel that is on with the key only, and wire the power to there. Then just ground it to the chassis/body somewhere. 
