Should I run it

Reply Subscribe

Thread Tools

Search this Thread

Apr 11, 2012 | 06:57 PM

Sinisterking

Thread Starter

Teching In

Joined: Apr 2012

Posts: 2

Likes: 0

From: KCMO

Should I run it

long story short. 96 lt1 hotcam .026 gasket stock head no machining.
Heres my mark. this is with stock pushrods. Do I need 7.150 or would they be too short? really though

Apr 11, 2012 | 07:42 PM

bowtienut

TECH Fanatic

iTrader: (1)

Joined: Mar 2007

Posts: 1,685

Likes: 5

From: Bright, IN

Roller rockers? If so, I'd run it.
Big cams usually sweep out at least that far.

Apr 11, 2012 | 10:02 PM

SoxXpupPeT

TECH Junkie

iTrader: (34)

Joined: May 2008

Posts: 3,431

Likes: 1

From: Yonkers, NY

I would get myself an adjustable pushrod checker and a dummy spring for the valve. read the instructions and test afew different combos out. I ended up running stock length pushrods (7.200") for my setup. 1.6 full rollers, LS7 roller lifters .026" gaskets and .010" milled heads. Lines almost perfect. Its important to get it as good as possible. If thats as good as you can get it after you check it then leave it. BTW if the line favors the exhaust side alittle bit thats more preferred

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last