Wiring harness question
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Jun 2012
Location: Jacksonville, Fl
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Wiring harness question
I need to replace the engine harness on my 97 ta. I have the lt1 with a t56. I've found a harness from a 96 lt1 with an automatic transmission. Will this harness work on my car?
#3
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Jun 2012
Location: Jacksonville, Fl
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Thank you for the response. I think I use your website a lot, unless I have you mixed up with someone else.
#4
TECH Veteran
Trending Topics
#8
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Jun 2012
Location: Jacksonville, Fl
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
The previous owner somehow got a fire going under the hood. Heat + electrical tape on everything made everything a sticky mess. Some connectors are melted, and there's a lot of exposed spots. Somehow everything still works.
Here's an example for you. Look at the grounds on the right, and the iac connector on the left.
Here's an example for you. Look at the grounds on the right, and the iac connector on the left.
#9
TECH Fanatic
iTrader: (7)
It's really not that bad, all you'd have to do is splice your existing T56 connectors into the A4 harness. All the PCM wiring is already in the A4 harness, it's just a matter of hooking up to the right wires. The only issue would be reverse lights, I'd have to look through the schematics to figure that out.
#11
TECH Veteran
-rear O2s
-crank position sensor
-EVAP vacuum switch
and it will have a different coil connector.