mdacton

iTrader: (3)

With a HV pimp I was sucking pan dry at 7500. I will never use a HV in a small block again its completely not neeeded ever. SBC has one of the best oiling systems stock.

To the OP I would use a mechanical test gauge and verify what you have first, if its not within spec cut the filter open and see whats in the media

SAPPER

iTrader: (10)

Was this a Cam motion gear or from the CM cam?

quik95lt1

iTrader: (7)

drainback issues........i had the same issue i had to overfill 1qt to avoid the issue when backing off the throttle on the top end.........i fixed the oil passge issue on the back hole of the head and did some other drain back issues and now its perfectly fine.......i run a HV pump and have no issues with the pump sucking the pan dry

vieira28

Hey, I have a few questions if you dnt mind. Hope to here from you..

96capricemgr

iTrader: (1)

Just start a new thread, this one is old and some of the posters don't even post anymore.