Rip back apart or install it? LT1 355

Reply Subscribe

Thread Tools

Search this Thread

Jan 16, 2014 | 10:30 AM

BLWNLT1_T/A

Thread Starter

TECH Enthusiast

iTrader: (12)

Joined: Aug 2006

Posts: 533

Likes: 0

From: Texas

Rip back apart or install it? LT1 355

Longs story short. I have a built 355 that has been sitting for about 6 years covered up of course. All I need to do is install itake, oil pump and oil pan to start install. Should I install or go through everything again? Everything is new in this block no used parts all still looks nice and shiny.

Jan 16, 2014 | 11:11 AM

nomoneyz

TECH Fanatic

iTrader: (15)

Joined: Aug 2006

Posts: 1,458

Likes: 1

From: Apple Valley - So Cal

Where was it stored at? I've never tried firing an engine after that long but if it was stored properly I don't see why you shouldn't run it.

Jan 16, 2014 | 11:20 AM

96lt1m6

TECH Junkie

iTrader: (31)

Joined: Jan 2006

Posts: 3,782

Likes: 3

From: LA$ VEGA$

I would go for it just be sure to prime that oil pump.

Jan 16, 2014 | 11:54 AM

nitrous2fast

TECH Fanatic

iTrader: (2)

Joined: Dec 2010

Posts: 1,084

Likes: 0

From: Oklahoma

check the cylinder walls for rust. if none, put it together and have fun.

Jan 16, 2014 | 07:54 PM

LilJayV10

TECH Senior Member

iTrader: (39)

Joined: Apr 2007

Posts: 9,716

Likes: 999

From: Evansville,IN

If it has been stored properly I'd put some marvel mystery oil in each of the cylinders and let it sit over night. turn it over by hand several times to ensure everything is free. pressure prime it and let her eat.

Jan 16, 2014 | 10:57 PM

BLWNLT1_T/A

Thread Starter

TECH Enthusiast

iTrader: (12)

Joined: Aug 2006

Posts: 533

Likes: 0

From: Texas

Had it stored in a shop covered up on an engine stand. All still looks like the day I covered it up. I flipped it over and everything is still nice and shiny...

Reply Subscribe