installed rear now it vibrates
#1
On The Tree
Thread Starter
iTrader: (1)
Join Date: Apr 2008
Location: LaPlata, MD
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
installed rear now it vibrates
Not sure if this is in the correct section but I bought a strange s60 with the driveshaft Installed everything and now I have a bad vibration under at around 30 mph I have umi adj LCA adj TA adj PB everything is brand new. Could it be my driveshaft angle causing the vibration ? Any input appreciated I did a search and found most people have vibration at higher speeds while mine is under 40 ( I don't know if it clears up past 40 I didn't try risking it )
Last edited by Cam95Maro; 04-11-2014 at 02:08 PM.
#5
TECH Apprentice
iTrader: (7)
Join Date: May 2005
Location: Upland, CA
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
It is most likely pinion angle, as mentioned above. However, I have an S60 on my 99 and the torque arm bracket in the rear contacts the tunnel because of how much bigger the rear is. It causes a vibration throughout the body at certain speeds. You might have the same issue if you are lowered like I am. You just need to BFH the tunnel to clear out some room. I really need to do that soon.
#6
On The Tree
Thread Starter
iTrader: (1)
Join Date: Apr 2008
Location: LaPlata, MD
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
I was told about the hitting the tunnel and I used a bfh to clear some room maybe I didn't go big enough I will look at it Tom and see if it is contacting the body thanks for the input guys