Looking to make a forged bottom end...
Thread Starter
TECH Enthusiast
Joined: Mar 2004
Posts: 586
Likes: 0
From: Tinley Park
Looking to make a forged bottom end... I'm looking to make a forged bottom end for my 350. I found most of what i need (i think) on through summit racing. However, I'm not sure what bearings I need.
Also would someone be nice enough to look over what I have selected and tell me what they think and more importantly if it will all work.
Thanks
Pistons
Crank
Ring set
Connecting Rods
The one thing i wasn't 100% sure on was the bolt size for the connecting rods.
Also would someone be nice enough to look over what I have selected and tell me what they think and more importantly if it will all work.
Thanks
Pistons
Crank
Ring set
Connecting Rods
The one thing i wasn't 100% sure on was the bolt size for the connecting rods.
You are kinda all over the place with parts quality IMO. What are you trying to do with the motor, rpm and power wise, NA / nitrous / boosted?
I wouldnt buy bearings. I would let the engine builder pick them out b/c depending on clearences, you might not have the right size. Tell them you want to run "XX" brand, and let them do the rest.
I wouldnt buy bearings. I would let the engine builder pick them out b/c depending on clearences, you might not have the right size. Tell them you want to run "XX" brand, and let them do the rest.
