help on adjusting roller rockers...
Thread Starter
TECH Regular
Joined: Nov 2004
Posts: 440
Likes: 0
From: league city,tx
help on adjusting roller rockers... Can anyone give me some tips on adjusting roller rockers? Just replaced heads and looking for any shortcuts on putting rollers back on...any help is appreciated.
IIRC (someone please correct me if I'm wrong) But I followed the TDC method and I set the rocker to 0 lash and then gave the nut 3 good 1/4 turns, and then reefed down on the locks. Then again that's How I remember setting mine up?
Staging Lane
Joined: Mar 2004
Posts: 72
Likes: 0
From: Tallahassee, FL
Staging Lane
Joined: Feb 2005
Posts: 80
Likes: 0
From: Detroit area (Waterford)
It is the same as the gen 1 sbcs, EOIC= Exhaust Open, Intake Closed. Which means right when the exhaust is beggining to open (as close to the actual start of movement as possible) you adjust your intake. Just as your intake beggins to close you then adjust your exhaust. Of course it is easiest to do this with a second person handy to bump the engine (just don't forget to disconnect the coil) unless you have the engine out and then you can obviously turn the crank maunally. Also make sure you tighten the snot out of your set screws since I didn't once, and only once (ouch).
-Jon
-Jon
