input shaft advice
Thread Starter
Staging Lane
Joined: Dec 2003
Posts: 81
Likes: 0
From: Acworth, GA
input shaft advice im trying to get this input shaft to go into the back of the motor its into the pressure plate i just can't get the splined shaft into the clutch i lined it up with the dummy shaft before i tightend the pressure plate. i rotated the motor to try to line it up and just can't get it to work.
any suggestions or help would be appreciated
any suggestions or help would be appreciated
Last edited by radd; Apr 1, 2006 at 11:43 AM.
Staging Lane
Joined: Mar 2006
Posts: 62
Likes: 0
look for the clutch alignment tool that came with your clutch.
I couldn't find mine when I was putting in my engine and tranny so I just lined them up out of the car...But Im assuming your engine is already back in.
I couldn't find mine when I was putting in my engine and tranny so I just lined them up out of the car...But Im assuming your engine is already back in.
Thread Starter
Staging Lane
Joined: Dec 2003
Posts: 81
Likes: 0
From: Acworth, GA
Ended up dropping the damn tranny !
and dropped it in the way i was told can't be done!
it was a bitch but she is in and electrical is getting finished marrow and maybe adjusting some rockers marrow evening.
and dropped it in the way i was told can't be done!
it was a bitch but she is in and electrical is getting finished marrow and maybe adjusting some rockers marrow evening.
