WTF i read through that fast. I was on my lunch break. I guess asking questions gets nowhere around here huh.

 

well you asked a VERY basic question then said

thats why your getting a hard time

 

well yeah because i can do the assembly of the motor just cannot do the machining. I have experience in the reassembly and disassembly of many diff. motors. I just was needing to clear up that the 355 infact was an overbored 350 because there were guys even on here talking about "my stroked 355 LT1 this and my stroked 355 LT1 that" and i remember my brother and I talking about it and him saying that to build a 355 out of the LT1 you needed to bore the cylinders but did not remember how much. Guess the machine shop would have known that but still, I come here for ANY questions I have because you get a straight answer not any BS run around.