LT1-LT4 Modifications 1993-97 Gen II Small Block V8

super comp LT's touching

Thread Tools
 
Search this Thread
 
Old Apr 22, 2007 | 09:16 PM
  #1  
94Pontiac's Avatar
Thread Starter
On The Tree
iTrader: (4)
 
Joined: Feb 2007
Posts: 150
Likes: 0
Default super comp LT's touching

so I installed my super comp lt's today. And the passenger side really really tight, its like touching or 1/16" away from the sub frame. And its also touching the wiring that goes for the abs. I am afraid to tart it because it will melt the **** out of the wiring and the ac box.

are they always this tight?

also the car is jacked up kinda redneck right now so maybe thats tweaking something? It has two jack stands up front, on the frame and the RR wheel is on a wheel ramp.

thanks
Reply
Old Apr 23, 2007 | 08:19 PM
  #2  
94Pontiac's Avatar
Thread Starter
On The Tree
iTrader: (4)
 
Joined: Feb 2007
Posts: 150
Likes: 0
Default

anyone running hooker lts?
Reply
Old Apr 23, 2007 | 08:34 PM
  #3  
BLACKSHARK's Avatar
12 Second Club
 
Joined: Jan 2007
Posts: 148
Likes: 0
From: JAX,FL/Ft.BLISS,TX
Default

Good choice in headers you won't be disapointed. Splice and extend your wires.After that wrap them in reflective heat wrap. Then secure them with zip ties. Do this with all your wires (o2 sensors,etc...). Finally get MSD wires with protective boots to go over them. I just went what you will go through. Sooner or later those headers will melt your spark plug wire. It may be pricy but it will be 3x more expensive if you dont protect all your wires from heat.
Reply
Old Apr 23, 2007 | 08:50 PM
  #4  
BizZzatch350's Avatar
Moderator
20 Year Member
Photogenic
iTrader: (33)
 
Joined: Dec 2001
Posts: 9,793
Likes: 15
From: T E X A S
Default

If its close to the K you may have sagging motor mounts, far as the abs, I had to undo the clip and move the harness out of the way.
Reply
Old Apr 23, 2007 | 08:51 PM
  #5  
94Pontiac's Avatar
Thread Starter
On The Tree
iTrader: (4)
 
Joined: Feb 2007
Posts: 150
Likes: 0
Default

yah i just bought msd wires, for a corvette cause theyre longer then fbody ones. i was going to go over valve cover. I am kinda worried about how close they are to the inner fender and heater box...
Reply
Old Apr 23, 2007 | 08:53 PM
  #6  
BizZzatch350's Avatar
Moderator
20 Year Member
Photogenic
iTrader: (33)
 
Joined: Dec 2001
Posts: 9,793
Likes: 15
From: T E X A S
Default

Also you may have to mess with the Cruise cable, I melted mine
Reply
Old Apr 23, 2007 | 10:15 PM
  #7  
94Pontiac's Avatar
Thread Starter
On The Tree
iTrader: (4)
 
Joined: Feb 2007
Posts: 150
Likes: 0
Default

I never thought of saggy mounts. now that you mention it I just went out there and pryed the mount and it moved easily, with no weight on it. Its an m6 so i guess urethane mounts are the best? any brand in particular?

yeah i'll move the wiring and cable tie it out of the way.
Reply
Old Apr 23, 2007 | 10:17 PM
  #8  
slick1851's Avatar
TECH Junkie
 
Joined: Nov 2003
Posts: 3,265
Likes: 1
From: CHITOWN
Default

Poly mounts are all pretty much the same def worth going with
Reply
LS1 Tech Stories

The Best V8 Stories One Small Block at Time

story-0

Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin

 Verdad Gallardo
story-1

6 Common C5 Corvette Failures and What's Involved In Repairing Them

 Pouria Savadkouei
story-2

Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph

 Verdad Gallardo
story-3

Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked

 Pouria Savadkouei
story-4

Top 10 Most Powerful Chevy Trucks Ever Made!

 
story-5

Hennessey's New Supercharged Silverado ZR2 Has 700 HP

 Verdad Gallardo
story-6

Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes

 Verdad Gallardo
story-7

Awesome K5 Blazer Restomod Comes With C7 Corvette Power

 Verdad Gallardo
story-8

10 Camaros You Should Never Buy

 
story-9

10 LS Engine Myths That Refuse to Die

 Verdad Gallardo
Old Apr 23, 2007 | 10:20 PM
  #9  
94Pontiac's Avatar
Thread Starter
On The Tree
iTrader: (4)
 
Joined: Feb 2007
Posts: 150
Likes: 0
Default

haha so i guess i should of done the motor mounts when I had the headers out. ah well i'll give it a try with them in.
Reply
Old Apr 24, 2007 | 01:09 PM
  #10  
BizZzatch350's Avatar
Moderator
20 Year Member
Photogenic
iTrader: (33)
 
Joined: Dec 2001
Posts: 9,793
Likes: 15
From: T E X A S
Default

Yea, its pretty common after LTs for them to hit on the K member, due to old mounts. I had actually bought new mounts for mine, but was so tired of the install, the stock mounts looked fine so I left them be. With my abs, I was unable to unhook a the harness and pull it out of the way, pulled the harness through the frame so the I think the clip is flush with the fender well, away from the LT. I had a main engine harness to the O2 I think that had to be unhooked and pulled away so it don't get burned up. Kinda funny, they didn't design these cars with Long Tubes in mind, becomes aparent on that horrible install
Reply
Old Apr 24, 2007 | 03:31 PM
  #11  
Javier97Z28's Avatar
11 Second Club
iTrader: (1)
 
Joined: Nov 2001
Posts: 340
Likes: 1
From: WPB, Fl
Default

Agreed on the sagging mounts. My LT's have much more clearance now after installing new urethane mounts with my motor swap.
Reply
Old Apr 24, 2007 | 07:11 PM
  #12  
94Pontiac's Avatar
Thread Starter
On The Tree
iTrader: (4)
 
Joined: Feb 2007
Posts: 150
Likes: 0
Default

thx for the input, yeah the passenger side header was definably a ***** of a job. anyone install the mounts with headers in?
Reply




All times are GMT -5. The time now is 01:40 AM.

story-0
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin

Slideshow: This heavily modified 1971 Camaro mixes classic muscle car styling with a fifth-generation Camaro interior and modern LS3 power.

By Verdad Gallardo | 2026-05-12 18:06:42


VIEW MORE
story-1
6 Common C5 Corvette Failures and What's Involved In Repairing Them

Slideshow: From wobbling harmonic balancers to failed EBCMs, these are the issues that define long-term C5 ownership and what repairs typically involve.

By Pouria Savadkouei | 2026-05-07 18:44:57


VIEW MORE
story-2
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph

Slideshow: A modern Camaro transformed into a retro icon, this limited-run "Bandit" build blends nostalgia with brute force in a way few revivals manage.

By Verdad Gallardo | 2026-04-21 13:57:02


VIEW MORE
story-3
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked

Slideshow: Cadillac didn't just crash the high-performance luxury vehicle party, it showed up loud, supercharged, and occasionally a little unhinged...

By Pouria Savadkouei | 2026-04-16 10:05:15


VIEW MORE
story-4
Top 10 Most Powerful Chevy Trucks Ever Made!

Slideshow: Top ten most powerful Chevy trucks ever made

By | 2026-03-25 09:22:26


VIEW MORE
story-5
Hennessey's New Supercharged Silverado ZR2 Has 700 HP

Slideshow: Hennessey has turned the Silverado ZR2 into a 700-hp off-road monster with supercharged V8 power and a limited production run.

By Verdad Gallardo | 2026-03-24 18:57:52


VIEW MORE
story-6
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes

Slideshow: A one-off sports car that looks like a vintage Italian exotic-but hides a C6 Corvette underneath-just sold for the price of a new mid-engine Corvette.

By Verdad Gallardo | 2026-03-23 18:53:41


VIEW MORE
story-7
Awesome K5 Blazer Restomod Comes With C7 Corvette Power

Slideshow: A heavily reworked 1972 K5 Blazer swaps its off-road roots for a low-slung street-focused build with modern V8 power.

By Verdad Gallardo | 2026-03-09 18:08:45


VIEW MORE
story-8
10 Camaros You Should Never Buy

Slideshow: There are thousands of used Camaros on the market but we think you should avoid these 10

By | 2026-02-17 17:09:30


VIEW MORE
story-9
10 LS Engine Myths That Refuse to Die

Slideshows: Which one of these myths do you believe?

By Verdad Gallardo | 2026-01-28 18:10:11


VIEW MORE