help with setup
help with setup my motor is in need of being rebuilt. the problem is that my heads have been milled down .080 and its not worth porting them. i want to go with stock crank and rods, with new pistons, bearings, etc. i will also be going with a bigger cam, probably the cc503.
i do not have a lot of cash on hand right now and was not expecting building the motor this early, and was wondering if it is safe to use the stock rockers (with new springs) for a while until i can afford new heads, or am i going to NEED to buy 1.6 rollers.
also i was wondering what type of numbers people are seeing with this cam with ported/ aftermarket heads.
i do not have a lot of cash on hand right now and was not expecting building the motor this early, and was wondering if it is safe to use the stock rockers (with new springs) for a while until i can afford new heads, or am i going to NEED to buy 1.6 rollers.
also i was wondering what type of numbers people are seeing with this cam with ported/ aftermarket heads.
Last edited by IronOutlaw; Apr 10, 2008 at 08:13 PM.
