Master Cylinder install question (in the process)

Reply Subscribe

Thread Tools

Search this Thread

Nov 2, 2003 | 01:58 PM

blkbeaZ28

Thread Starter

TECH Fanatic

iTrader: (4)

Joined: Nov 2002

Posts: 1,771

Likes: 0

From: Sugar Land, TX

Master Cylinder install question (in the process)

Can some one please tell me how you disconnect the braided hose from the tranny?

Thanks Gilbert

Nov 2, 2003 | 02:21 PM

blkbeaZ28

Thread Starter

TECH Fanatic

iTrader: (4)

Joined: Nov 2002

Posts: 1,771

Likes: 0

From: Sugar Land, TX

Never mind got it. Now what is this U-clamp deal?

Gilbert

Nov 2, 2003 | 03:35 PM

blkbeaZ28

Thread Starter

TECH Fanatic

iTrader: (4)

Joined: Nov 2002

Posts: 1,771

Likes: 0

From: Sugar Land, TX

got that too.

Nov 2, 2003 | 09:29 PM

Mike K.

TECH Junkie

Joined: Dec 2001

Posts: 3,242

Likes: 0

From: Lakeland, FL

that U clamp was harder to put in than the tranny if you ask me, are you putting in a new clutch or just the master?

Nov 2, 2003 | 11:03 PM

SSEUL8R

TECH Apprentice

Joined: Aug 2003

Posts: 335

Likes: 0

From: Vacaville, CA

Are you talkin about the ubolt that goes over the top of the master cylinder? Cuz i removed that when i put my Mcleod in, because you dont need it. The Mcleod has threaded holes in it, and you bolt it up from the inside.

Nov 2, 2003 | 11:15 PM

Jason99T/A

I can shift faster than you.

iTrader: (21)

Joined: Nov 2001

Posts: 5,133

Likes: 0

From: Baton Rouge, LA

The new Mcleod m/c come with bolts that thread into the m/c. The older version reused the factory u-bolt.

Nov 2, 2003 | 11:20 PM

SSEUL8R

TECH Apprentice

Joined: Aug 2003

Posts: 335

Likes: 0

From: Vacaville, CA

Quote:

Originally Posted by Jason99T/A

The new Mcleod m/c come with bolts that thread into the m/c. The older version reused the factory u-bolt.

Glad I got the new one, that ubolt would have been terrible to try to put back in by myself.

Trending Topics

Epic SRK B/S thread of 2019

12.7k

564.4k
Canted valve heads

126

14.9k
Is this catch can setup safe to run like this?

8

207
Possible Purchase Evaluation Help

7

174
Terminator X O2 heater circuit voltage question

8

230

Nov 2, 2003 | 11:36 PM

blkbeaZ28

Thread Starter

TECH Fanatic

iTrader: (4)

Joined: Nov 2002

Posts: 1,771

Likes: 0

From: Sugar Land, TX

I thought about throwing away the U-bolt and just using two bolts but a friend and I managed to get it back on. Mike I installed just the MC that I bought from you . ( Thanks for the fast shipping) it also worked out pretty good. I ran the car 4 times at the track tonight. My stock clutch is holding up pretty good so far.

Thanks for all the repies.
Gilbert