Slave hydro line conversion?
Slave hydro line conversion? Does anybody sell a clutch slave cylinder hydraulic hose conversion kit?
Basically what I'm needing is the hydraulic braided line that comes out of the slave converted at the M/C end to a flare fitting or a AN fitting - basically something I can work with.
Has anybody seen anything like this? I was certain something existed considering all the hybrid LS1/T56 combos but when I search online I don't see what I'm looking for.
Basically what I'm needing is the hydraulic braided line that comes out of the slave converted at the M/C end to a flare fitting or a AN fitting - basically something I can work with.
Has anybody seen anything like this? I was certain something existed considering all the hybrid LS1/T56 combos but when I search online I don't see what I'm looking for.
Okay I found what I'm looking for.
For searchability of this thread in the future here are the numbers:
McLeod (roll pin fitting to at M/C end of hose to -4AN): #139026 ~$40 but comes with new roll pin. #139027 is the same thing but a 90 degree fitting and ~$50.
Russell (roll pin fitting to at M/C end of hose to -3AN): #640281 ~$20 does not come with new roll pin, and -3AN may be a little too small for proper clutch performance.
For searchability of this thread in the future here are the numbers:
McLeod (roll pin fitting to at M/C end of hose to -4AN): #139026 ~$40 but comes with new roll pin. #139027 is the same thing but a 90 degree fitting and ~$50.
Russell (roll pin fitting to at M/C end of hose to -3AN): #640281 ~$20 does not come with new roll pin, and -3AN may be a little too small for proper clutch performance.
