hydraulic line to slave

Reply Subscribe

Thread Tools

Search this Thread

Jun 11, 2010 | 01:33 AM

phdraperinc

Thread Starter

Staging Lane

iTrader: (1)

Joined: Jan 2006

Posts: 80

Likes: 0

hydraulic line to slave

Basically is there an easy way to disconnect the hydraulic line from the slave if that plastic insert is messed up? I've taken these off 100 times and I've always had issues with mine. I'm not sure if it's just broken or what but I can't get it to budge right now and the plastic ring is pressed all the way in. Last few times I had to disconnect the master and pull it through and I HATED doing that.

So like I just asked, is there an easy way to disconnect the cable WITHOUT pulling the master or pulling the tranny off carefully and unbolting the slave?

Is there any place I can get a new plastic ring for the line?

Jun 11, 2010 | 05:10 PM

Billy M

FormerVendor

Joined: Dec 2008

Posts: 287

Likes: 0

From: Anaheim, Ca

We mfg a quick disconnect tool P/N 139080. We also mfg a replacement line kit with steel braided AN-4 line and a roll pin fitting to plug into your factory master P/N 139212.

Jun 13, 2010 | 02:31 PM

phdraperinc

Thread Starter

Staging Lane

iTrader: (1)

Joined: Jan 2006

Posts: 80

Likes: 0

Quote:

Originally Posted by Billy M

We mfg a quick disconnect tool P/N 139080. We also mfg a replacement line kit with steel braided AN-4 line and a roll pin fitting to plug into your factory master P/N 139212.

i wasn't able to find the quick disconnect tool you mentioned on the site. you have the direct link?

Jun 14, 2010 | 10:26 AM

Billy M

FormerVendor

Joined: Dec 2008

Posts: 287

Likes: 0

From: Anaheim, Ca

This tool is a component item and we don't list components on our website.

Here is a sample of the tool. If you want to PM me with your address I'll send you out one.

Attached Thumbnails

Reply Subscribe