questions before i attempt this
Thread Starter
TECH Enthusiast
Joined: Jul 2003
Posts: 608
Likes: 0
From: fortress of solitude
questions before i attempt this ok right now i have plans to put my clutch in next weekend..i have LT Jet Hots(see sig) and i am replacing the clutch and the slave and master cylinder. WILL I HAVE TO REMOVE ANY OF THE EXHAUST SYSTEM?? the reason i ask is because it is all wielded together... i have heard that i wouldnt but i would like to verify before i decide to set aside a whole day to do this(2 people are helping with this too) also, given i have the proper tools with 3 people, about how long should it take to do the complete install. we have access to a rack so that should help.
TECH Resident
Joined: Jul 2003
Posts: 858
Likes: 0
From: Everywhere
u might need to remove ur Y pipe(i didn't) and it will be alot easier on a rack
took me 45 mint to remove my tranny 4L60E in the shop with all the tools i need(lines were off already and drive shift)
took me 45 mint to remove my tranny 4L60E in the shop with all the tools i need(lines were off already and drive shift)
Thread Starter
TECH Enthusiast
Joined: Jul 2003
Posts: 608
Likes: 0
From: fortress of solitude
about how much room (ballpark) will it take to pull the transmission out? i have the jet hot y and IMO i dont think ill have a problem but i dont want to attempt to take it out if i know im not going to have enough room
