spec went out
![6']['9's Avatar](https://ls1tech.com/forums/customavatars/avatar7527_3.gif){kind=avatar}
Thread Starter
TECH Fanatic
iTrader: (2)
Joined: Oct 2002
Posts: 1,240
Likes: 0
From: San Antonio Tx
spec went out after bleedin the hydraulics i think my cluth is toast 
clutch sticks to floor, master cylinder resivor is full, no fluid is on the floor. when im driving the car will stay in gear, when i push the clutch in it feels like i had it @ wot and slows very hard. any how i have a spec3 do i have to buy a new one or can i get somekind of rebuild kit. i was told that i could just get a new pressure plate and resurface the flywheel . so what am i supposed to do
thanks
jay
clutch sticks to floor, master cylinder resivor is full, no fluid is on the floor. when im driving the car will stay in gear, when i push the clutch in it feels like i had it @ wot and slows very hard. any how i have a spec3 do i have to buy a new one or can i get somekind of rebuild kit. i was told that i could just get a new pressure plate and resurface the flywheel . so what am i supposed to do thanks
jay
