need help with the monster clutch install
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: Apr 2010
Location: roanoke rapids
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
need help with the monster clutch install
i am replacing my stock clutch with the monster stage 3 i will be contacting monster tomorrow but was wondering if anybody could help me. i did not order the slave cylinder because its only a year old and only has about 1500 miles on it. i received a release bearing, how do i put that on my stock slave cylinder? i have to get this in tomorrow i am having my car ran on the dyno with 150 shot Friday and need to get some miles on the clutch.
#3
Teching In
Thread Starter
iTrader: (1)
Join Date: Apr 2010
Location: roanoke rapids
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
the one monster sent seems much nicer than the stock one i looked it up i think you turn it until it stops and then pull it off but i dont feel safe due to the fact i googled that i was hoping somebody has done it and could help