T56 Release Fork Question
T56 Release Fork Question The release fork on my t56 came with some damage. The metal retainer looking part is in pretty bad shape, looks like it was bent during removal. How much of an issue will this be? I am trying to bend it back into place or find another solution so I don't have to spend another hundred dollars on a fork. Any advice would be great thanks ahead of time.
TECH Veteran
Joined: Apr 2008
Posts: 4,985
Likes: 112
you can try and bend it back....if it were my car I would spend the $100 for a new one, and I did just that.
maybe try heating the clip with a torch so it will bend back but that clip looks thin. Don't know if you can buy a new clip alone and drill old one out and rivet back
maybe try heating the clip with a torch so it will bend back but that clip looks thin. Don't know if you can buy a new clip alone and drill old one out and rivet back
you can try and bend it back....if it were my car I would spend the $100 for a new one, and I did just that.
maybe try heating the clip with a torch so it will bend back but that clip looks thin. Don't know if you can buy a new clip alone and drill old one out and rivet back
maybe try heating the clip with a torch so it will bend back but that clip looks thin. Don't know if you can buy a new clip alone and drill old one out and rivet back
TECH Veteran
Joined: Apr 2008
Posts: 4,985
Likes: 112
I got it at www.thegearbox.org 734.793.0727. part#1386-596-004
also bought a new bolt & "T" stud from them. Don't know if they just sell the clip, contact them.
also bought a new bolt & "T" stud from them. Don't know if they just sell the clip, contact them.
