What's the drill mod
 

I've read a few posts of guys with M6 talking about
the "drill mod". Anyone know about it. Pros/cons

THANKS

Drilling out the inside of the Hydraulic line at the Master cylinder end of the Hose.
All Pro , No CONs

So what are the advantages.

Fluid can move faster. ( bigger hole)
That means the Clutch will engage faster.

Someone should Post up the link to the How to on this
I dont' remember where its at

I thought I saw it on Chevy High Performance online....it's at home, I saved it. I'll link it up tonight if no one beats me to it.

I'm doing the mod for sure.

Its not real hard
You have to remove your Master,(if it's never been removed this is a pain in the ass)
There is a Clip ring that you can't see, but once you know about it, well it's easier.
You have to disconnect the line from the Slave from under the car. Its a Quick disconnect.
once the whole thing is out.
you remove the Line from the Master , by punching out a pin, then you drill out the inside of the fitting that goes into the master.
Make sure you get all the Crap out , put it all together , bench bleed the master.
You might need the Step by step. I'm gettin tired of typing.
Didn't install university have this too?
I'll check

Yea
Goto www.intalluniversity.com
Hit the intall documents button on the left under Main.
Then scroll down to Transmission
look for Drill mod, mcleod master install.

You have a choice!

http://www.chevyhiperformance.com/howto/39021/

Mods, can we sticky stuff like this?