helpppp bleeding
Thread Starter
On The Tree
Joined: Mar 2013
Posts: 110
Likes: 14
From: Puerto Rico
helpppp bleeding I put an ls7 clutch and new slave cilinder on my ls1 camaro. I did the drill mod on the master cylinder also. I fill the reseivor and bleed the line until fluid came out. I put the line in the slave and push the pedal like 10 times and open the slave bleeder. On the first times i hear air coming out but after that it Just keep coming slow fluid and i hear like a squeal like shhhh but súper fast. Also I have done it like 3 hours an nothing. Please help me. I dont have mity mac ir whatever im doing it the Old way. Please help
You can rent a mighty vac at autozone for free. Most bleeding problems are from air stuck in the master which the mighty vac solves
You want to crack the bleeder and slowly push the pedal down. Close the bleeder before the clutch is fully depressed. Pull the clutch pedal back up and pump it a few times. Then crack the bleeder and repeat till nothing but fluid comes out
You want to crack the bleeder and slowly push the pedal down. Close the bleeder before the clutch is fully depressed. Pull the clutch pedal back up and pump it a few times. Then crack the bleeder and repeat till nothing but fluid comes out
12 Second Club
Joined: Apr 2013
Posts: 232
Likes: 0
From: Bourg La
Did you install a quick bleeder for the slave? If you did get one. The easiest way I found to bleed my system is take the end of your speed bleeder and put it in a disposable cup of some sort an fill that cup up with the brake fluid. (make sure the bleeder is cracked open) Fill Your reservoir with fluid as well and slowly pump the pedal allowing a few seconds at the top and bottom of the pedal travel. Just make sure the end stays submerged and your reservoir doesn't go empty... Repeat the pumping until all the air is out. I used a clear cup so i can see the fluid coming out of the line. This is how I did mine and haven't had any issuse.
