I have searched and searched, albeit probably incorrectly, as I am sure this answer has been covered. I have been swapping in a ls3/tr6060 combo into my bimmer, and I did not put much though into the slave that sits inside of the tr6060 bell housing as bmw had an external slave. The tranny is already installed in the vehicle, and I didn't apportion the slave line. Is there an aftermarket slave hose that will attach to the slave? I would prefer not to remove the transmission if possible. I found this, but it is for a t56.
http://www.speedwaymotors.com/T56-Hy...rans,9086.html

 

I'll move this to a more appropriate section since this doesn't have anything to do with engine internals.