poor shift
Thread Starter
Teching In
Joined: Oct 2003
Posts: 13
Likes: 0
poor shift I have a 2000 WS-6. I,m not a rough shifter but of late if I wind up on the
tach 4000 PLUS rpm and try to throw a quick shift into 2nd I get a grinding
spinning type of noise. It is not in every gear. Could the slave and masters slow shifting have caused this? Could a slider or synchro be bad? Also are the
synchro in a firebird and a vette the same?
Thanks
tach 4000 PLUS rpm and try to throw a quick shift into 2nd I get a grinding
spinning type of noise. It is not in every gear. Could the slave and masters slow shifting have caused this? Could a slider or synchro be bad? Also are the
synchro in a firebird and a vette the same?
Thanks
You must do the drill mod (do a search for drill mod for your clutch to operate properly. Period.
After performing the drill mod, I use the jmd method (search for jmd method) to get rid of all air in the hydraulics.
Until it is drilled and bled, nothing matters in the diagnosis.
After performing the drill mod, I use the jmd method (search for jmd method) to get rid of all air in the hydraulics.
Until it is drilled and bled, nothing matters in the diagnosis.
