T/A rocker

I got a Spec 2 and billet steel flywheel, new hydraulics, throwout bearing, everything, all new. Have been breaking this clutch in almost 500 miles now, and it STILL chatters like a complete beotch !! Will it ever quit chattering or are these just a POS clutch?
I don't know of anything that could have been done wrong in the install, all surfaces were clean and all parts were new....

oange ss

iTrader: (50)

mine never chattered....take it to a lonely road and do a 4000 rpm clutch dump on it..it should clear up a bit

MeentSS02

iTrader: (11)

Specs are a hit and miss clutch...some chatter, some don't. If doing a high RPM clutch dump doesn't cure it a bit, you might have a bad clutch.

camaro99z

Mine doesn't chatter much at all...just a little bit if I don't give it enough gas in 1st gear.

T/A rocker

Update !
well Spec instructions said to break in for at least 450 miles, so today, with 486 miles on the new clutch, I let it have it ! I did a couple 4000 RPM dumps, and then beat on it some more. That took care of it. Happy to say the chatter is barely there at all now!
I got a pro 5.0 w /lou's short stick on the way, so I'll be ready raise some hell on it now!