Shift Rail assembly
Thread Starter
11 Second Club
Joined: May 2003
Posts: 764
Likes: 0
From: Glasgow, Ky
Shift Rail assembly While completing the rebuild on my t56 we encountered a problem with the shift rail does anyone have a good picture as to how the rail assembly mates to the shift forks? Circled is what I'm looking for, the write up on LS2.com is nice but this is one picture I can't seem to find a good shot of.
Teching In
Joined: Sep 2005
Posts: 18
Likes: 0
hey i work at gm and i rebuild this things all the time aint that a bitch to figure out my first one i like to never firgured out. ill find something better for you just pm me or email me. des435race@hotmail.com i can tell you you how to get it.
dewayne
dewayne
Teching In
Joined: Sep 2005
Posts: 18
Likes: 0
when you slide the shaft that control 5th and 6th and reverse in to place it just sits on the piece that your 1-2 and 3-4th forks are on. just rotate the center part of the shift fork control so it has enough room to fit im working on a better picture
