Questions on Ripper Shifter
Thread Starter
TECH Enthusiast
iTrader: (2)
Joined: Apr 2004
Posts: 636
Likes: 0
From: HOUSTON TEXAS
Questions on Ripper Shifter I have a few question, i bought the car with the B&M Ripper in it. I know am wondering:
1. Can i switch the ****? Is there a certain size?
2. Can i make the actual stick shorter/or replace it?
if so where is the best place to purchase these things.
pardon my ignorance.
1. Can i switch the ****? Is there a certain size?
2. Can i make the actual stick shorter/or replace it?
if so where is the best place to purchase these things.
pardon my ignorance.
If you have the 2 piece Ripper, you can cut down the shift lever by doing some welding. My buddy got about a inch and a half off of it, and cut the bottom of the shift **** so the boot fits perfectly under it, and it doesnt always fall down. If you have the one piece, I dont think you can cut it down. You can use different shift *****. I have a stock hurst shift **** on mine.
Thread Starter
TECH Enthusiast
iTrader: (2)
Joined: Apr 2004
Posts: 636
Likes: 0
From: HOUSTON TEXAS
thanks for the help guys, yeah my shifter sticks out like 2 inches past my boot, not a real big deal, but seen some that are REAL short and just wanted to know my options
Originally Posted by camarodave98
thanks for the help guys, yeah my shifter sticks out like 2 inches past my boot, not a real big deal, but seen some that are REAL short and just wanted to know my options
